NS0-520 NetApp Certified Implementation Engineer - SAN Specialist ONTAP Questions and Answers

You must relocate a LUN from one AFF A700 HA pair to another AFF A300 HA pair while preserving all storage efficiencies. What are two ways to accomplish this task? (Choose two.)

After performing failover testing on a newly deployed MetroCluster configuration, some aggregates remain in a degraded state. Referring to the exhibit, which statement is true?

You are testing FCP paths failures on a 2-node Netapp AFF All SAN Array and verify that persistent ports are correctly enabled. Before testing, a host sees four optimized paths to a LUN. You perform a

node takeover and re-check the host.

Which statement is true after the node takeover?

An administrator who is using the Virtual Storage Console (VSC) creates a new FC datastore on an existing volume. While the datastore was provisioned, two hosts were in maintenance mode. When the maintenance was completed, the two hosts do not have access to the new datastore, but they have access to other datastores on the same volume.

In this scenario, what caused this result?

When setting up a VLAN for administrative security purposes, which four ports are the only important ports to include in the VLAN? (Choose four.)

You are a system administrator and responsible for a Netapp AFF A800 2-node ONTAP 9.8 cluster that is used only for SAN. Your SAN uses FC and FCoE on the same Cisco switches. You want to add

NVMe from the ONTAP controller to the same Cisco fabric. Which two statements are correct in this scenario? (choose two)

Which two requirements must be satisfied to run an Upgrade Advisor report on a Netapp All SAN Array? (choose two)

In a Linux environment, issues are reported concerning multipathing. You want to view the direct and indirect paths. In this scenario, which command would you use to accomplish this task?

You are designing a new 4-node AFF A400 SAN cluster with 20 ISCSI hosts. Each AFF A400 node will have four data LIFs. Each ISCSI host needs to access every LUN over two LIFs per node on every

SAN node.

In this scenario, which Netapp SAN feature enable this connectivity?

An administrator is asked to provision a SAN environment in which host applications can monitor LUN space and performance space reclamation.

Which LUN type would satisfy these requirements?

You upgraded your Linux hosts to SUSE Enterprise Linux 15. In this scenario, which two actions should you perform before you test asymmetric namespace access (ANA)? (Choose two)

During maintenance of an AFF A250 node, you want to move the SAN LIFs that are members of a port set. In this scenario, which two statements are true? (choose two)

You are asked to configure a small environment for a branch office. The customer has two new VMware ESXI hosts and a Netapp FAS2750 for the site. They want to allocate 10 GB for their ISCSI network to

be used for datastores. However, they do not want to purchase any new switches for the environment. In this scenario, Which statement is correct?

Which option needs to be set on a volume to guarantee that it cannot be affected by other volumes?

During testing, an administrator notices that the wrong subsystem was returned using the NVMe discover command. The administrator was expecting test0_subsystem as the subsystem

Referring to the exhibit, what would cause the discrepancy?

You are provisioning a LUN using an ISCSI initiator on an ESX host. You disable Ethernet flow control for all ports but are experiencing

Performance issues.

In this scenario, which two actions would improve the performance issue? (Choose two.)

Which option needs to be set on a LUN to guarantee that it cannot be affected by other LUNs in the volume?

A customer wants to use both Cisco FC and FCoE switches in their ONTAP environment. According to NetApp best practices, what are two requirements in this scenario? (Choose two.)

Exhibit.

Referring to the exhibit, which two statements are true? (Choose two.)

After completing the configuration of a new Brocade Fibre Channel switch, which command do you use to verify your configuration?

Which three components are required for NetApp iSCSI LUN access on Linux servers? (Choose three.)

Exhibit.

You are asked to change the iSCSl Target Node Name of an SVM named SVM1 that is serving data.

Referring to the exhibit, which two statements are correct? (Choose two.)

You are configuring both NVMe and FC on the same AFF A800 2-node ONTAP 9.5 cluster. You are configuring both protocols on the same Cisco FC network switches.

In this scenario, which configuration on the cluster is supported?

An administrator has an ONTAP cluster with SVMs and LUNs as shown in the exhibit. Hosts attempting to connect to LUNs mapped from SVM "C" are unable to see their LUNs. The hosts are not configured to connect to any other SVM.

Which action should be performed to restore multi-path connectivity to the LUNs in this scenario?

You connected your FAS8200 to a Brocade SAN switch. As shown in the exhibit, port 0e is not available.

In this scenario, which statement is correct?

A customer’s NetApp infrastructure is reaching end-of-life (EOL), and they want to inventory their NetApp cluster. The customer wants to make sure that the proposed technical refresh satisfies their growing data demands.

Which two tools would you use to help with this recommendation? (Choose two.)

Click the Exhibit button.

The LUN that is shown in the exhibit is mounted by a Windows 2016 server. In this scenario, which two statements are correct? (Choose two.)

On your ONTAP 9.5 cluster, you need to set up the onboard key manager with hardware-based security and volume encryption.

Which two licenses are required in this situation? (Choose two.)

A customer has an existing 8-node cluster that consists of six FAS2650 nodes and two FAS2554 nodes. The customer wants to expand the cluster by adding two AFF A220 nodes.

Which resource would be used to determine whether this configuration is supported?

What is a SAN best practice when initially configuring a Linux FC boot LUN?

You are planning to expand a SAN-only ONTAP 9.5 cluster that consists of eight AFF A700 nodes.

In this scenario, what is the maximum number of additional AFF A700 nodes that would be added?

An administrator wants to design an NVMe solution to connect Linux hosts to an ONTAP cluster. The proposed solution uses two Cisco MDS 9396T switches for each fabric in a top-of-rack design.

In this scenario, which statement is true?