HPE0-V15 Delta - Building HPE Hybrid IT Solutions Questions and Answers

Exhibit:

Which HPE ProLiant Server meets the customer's requirements?

Which HPE ProLiant Server meets the customer's requirements?

Refer to the exhibit.

Drag the correct protocols from the left to the appropriate area on the topology on the right.

A customer considers a new HPE ProLiant DL380 Gen10 as a hardware platform for their application and requires maximum physical security.

For each security-related server components, identify whether it needs to be ordered separately, or whether it is included as part of the server solution.

A customer is subject to regulatory requirements and their data is highly sensitive.

Which HPE Smart Array feature addresses their need for an level of security for data stored inside their server?

A solution Integrator is installing new equipment to the rack Click the recommended location area for R3000 Gen5 UPS.

A client needs a data center network for a highly-virtualized server environment. They have the following requirements

• 25 Gb connectivity from the servers to the top-of-rack switches

• support for iSCSl storage

• lowest possible latency between their VM farms, which are contained In separate cabinets and connected to different top-of-rack switches within the data center

• support for Python script interpretation and open APIs

Which networking product line and architecture should you recommend?

Read the question, and then refer to the exhibit.

display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0

An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.

The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.

What must you do to resolve this issue?

A customer is facing high and unpredictable latency on an HPE ProLiant DL380 Gen10 server equipped with P408i-a controller

Which tool can display an Array Diagnostic Report?

A customer purchased a Nimble HF20 a year ago They are experiencing an issue with a few of their VMware servers in the RTP Nimble date center and asked that you make a recommendation based on the data in infoSight.

What should you recommend'?