Refer to the exhibit.
Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.
What is a typical issue that could cause this output?
Network administrators need to track when traffic matches deny entry in an ACL applied to a port. They want the alert to be sent to a syslog server that is already set up to send logs.
What should administrators do to enable alerts?
Refer to the exhibits.
Exhibit 1
Exhibit 2
Switch-1 and Switch-2 are configured to provide VRRP in VLAN 2. The default gateway for VLAN 2 is set to the VRRP virtual IP. Client-1 in VLAN 2 cannot ping its default gateway.
Based on the exhibits, what can administrators determine?
Refer to the exhibits.
Exhibit 1
Exhibit 2
Traffic between servers in Area 1 takes a sub-optimal path rather than the link dedicated to VLAN 1000, subnet 10.0.0.0/30. Based on the exhibits, what can administrators do to create a better path for this traffic?
Which technologies can prevent split brain in a VSF fabric that includes Aruba 2930F switches?
A company wants to implement RADIUS authentication of all managers who log in to AOS-Switches via SSH. The RADIUS server also sends VSAs that indicate which commands users can enter, and switches must honor these.
What must the administrator do to meet the company’s requirements?
Refer to the exhibit.
Switch-1 is routing traffic to 192.0.2.0/24 over a less-than-optimal path. Which issue could prevent Switch-1 from selecting the first route listed in the table as a best BGP route?
Refer to the exhibit.
Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.
What is a typical issue that could cause this output?
The security plan for AOS-Switches requires protection from incoming malware traffic generated from a worm-or virus-infected host.
Which feature should be implemented to provide the required protection?
Refer to the exhibit.
Switch-1 is an AOS-switch that is operating at factory default settings for QoS and has type of service disabled. It receives a frame with 802.1p value 5 on trk1, on VLAN 2. How does the switch treat the frame when it forwards it on TRK2?
Refer to the exhibit.
An administrator created a backplane stack with the plug-and-play method, and did not alter the default backplane stacking settings. Later, two backplane stacking links failed, as shown in the exhibit.
What happens to the backplane stack after the failures?
A network administrator wants to use an ACL, acl1, to control traffic from devices in VLAN 12 as the traffic is routed out of VLAN 12. The ACL should not control traffic within the VLAN.
Which keyword should the administrator enter at the administrator enter at the end of this command:
Switch(config)# vlan 12 ip access-group acl1____
Refer to the exhibit.
The access layer AOS-Switches currently run DHCP snooping on VLAN 2 and connection rate filtering on edge ports. They are at default settings for ARP protection. A network administrator then enters these commands on each of the access layer switches:
Switch(config)# arp-protect vlan 2 Switch(config)# arp-protect
Which behavior accurse?
Refer to the exhibit.
The routing switches shown in the exhibit run OSPF on the links between each other. The commander in the Switch-1 VSF fabric goes down. Traffic is disrupted for several seconds.
What should a network administrator do to support a faster failover in a similar situation?
Refer to the exhibit.
A network administrator needs to deploy AOS-Switches that implement port-based tunneled node. Their Aruba controller has IP address 10.1.10.5/24. The architect has assigned tunneled-node endpoints to VLAN 20.
What is one issue with the current configuration planned for VLAN 20 on the switch?
Refer to the exhibits.
Exhibit 2
The network administrator configures the commands shown in Exhibit 2. Which mismatch will cause an issue?
Refer to the exhibits.
Exhibit 1
Exhibit 2
The exhibits show the current operational state for routes on Switch-3. The company wants Switch-3 to send all traffic to 172.16.0.0/16 through Switch-2.
Which single configuration change creates the desired behavior?
A network administrator wants to use Aruba AirWave to audit an AOS-Switch configuration. What is one requirement?
A network administrator enters this command on an AOS-Switch:
Switch(config)# radius-server host 10.1.3.3 time-window 60
Which behavior will the switch show?
Refer to the exhibit.
A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated link should forward the packet?
A network administrator applies port security to a port with the send-alarm action. What does the switch do if it detects traffic from an unauthorized MAC address on the port?
Aruba-ACSP | HPE6-A46 Questions Answers | HPE6-A46 Test Prep | Delta - Implementing Aruba Campus Switching Solutions Questions PDF | HPE6-A46 Online Exam | HPE6-A46 Practice Test | HPE6-A46 PDF | HPE6-A46 Test Questions | HPE6-A46 Study Material | HPE6-A46 Exam Preparation | HPE6-A46 Valid Dumps | HPE6-A46 Real Questions | Aruba-ACSP HPE6-A46 Exam Questions
TESTED 17 May 2024
