HPE6-A72 Aruba Certified Switching Associate Exam Questions and Answers

BGP

LLDP

OSPF

MPLS E. 802.3ad

a machine learning method of packet inspection for the purpose of choosing which dynamic routing protocol to automatically assign

a concept that applies to firewalls, when examining packets only up through Layer 4

a function of Policy Based Routing that examines the entire IPv4 header to forward traffic based on factors other than destination address

a firewall process of examining the packet header all the way to Layer 7 in order to determine if the packet should be permitted or denied

Most older legacy switches had high port bandwidth utilization and were future proof designed to meet today's power-over-Ethernet needs.

Requirements for PoE are normally addressed using AC to DC power adapters. Concerns for port security for IoT devices are usually addressed using default wired encryption that all 802.3 Ethernet switches provide.

While APs are common, most clients are still docked and only require traditional wired connections with only the occasional dedicated PoE switch to provide power for the low number of devices needed.

Clients tend to prefer wireless connections, raising the need for PoE port access. There is also a growing amount of IoT devices that require security and port authentication options.

show interface vlan 1111

show interface 1/1/1

show interface gigabit 1/1/1

show vlan 1111

UDP 1812 and UDP 1813

UDP 161

TCP 443

UDP 162

Access-2# ping6 172.16.1.97 vrf mgmt.

Access-2# ping 172.16.1.97

Access-2# ping 172.16.1.97 vrf default

Access-2# ping 172.16.1.97 vrf mgmt

a group of computer resources that communicates between geographically separate location

the connection between two separate buildings in the same campus

a network of devices over long distances but limited to within a single ISP

compute resources that are networked locally over wireless

PoE or PoE+ is only used with Ethernet that is carried over multi-mode fiber cabling.

Using switchports for this reason is unnecessary, because Aruba Access Points typically use an AC to DC

power adapter to draw power.

PoE or PoE+ enabled switchports are rarely used given concerns about causing electrical interference, with the data also carried over Ethernet cabling.

Most administrators use PoE or PoE+ enabled switchports to provide both Ethernet connectivity and power to the AP.