Pre-Order Your Advanced HPE Edge-to-Cloud Solutions Written Exam HPE7-V01

The correct answer is C. RPO 0 is the decisive requirement. A zero recovery point objective means the customer cannot lose acknowledged writes if a site fails. That requirement cannot be satisfied by asynchronous replication because asynchronous copy always introduces replication lag. The storage volumes backing the VMware datastores must be synchronously replicated between the two sites so that committed data exists at both locations before the write is considered protected. HPE Alletra Storage MP B10000 is designed for mission-critical block workloads and supports high-availability replication models, including synchronous Remote Copy / Peer Persistence designs for VMware environments. HPE documentation for Active Peer Persistence describes synchronous Remote Copy as the mechanism used for high-availability protection across arrays. Option A is incorrect because stretching or joining HPE Synergy frames across sites is not the mechanism that provides RPO 0. Option B can help with VMware policy-driven placement, but SPBM alone does not replicate data. Option D fails the RPO requirement. Reference/topics: DR architecture, RPO 0, synchronous replication, B10000 Remote Copy, VMware datastore protection.

The correct answer is C. The exhibit shows an HPE Alletra Storage MP B10000 configuration based on QLC flash, with raw capacity below the customer’s 450 TB target. The correct capacity adjustment is to increase the number of QLC drives in the system while selecting the sparing policy that maximizes available usable capacity for the intended design. Replacing QLC with TLC is not the right direction for a high-capacity all-flash requirement because QLC media is positioned for dense, cost-efficient capacity expansion. Adding host bus adapters does not increase raw storage capacity, so option A is unrelated to the requirement. Replacing controller nodes is also unnecessary because the problem is media capacity, not controller performance. HPE Alletra Storage MP B10000 QuickSpecs identify scale-out capacity characteristics, including maximum raw capacity per shelf, confirming that the platform is intended to scale capacity through shelves and drive population rather than by changing host-connectivity cards. The correct plan is to add QLC capacity to reach the raw-capacity target and adjust sparing appropriately. Reference/topics: B10000 capacity planning, QLC all-flash sizing, sparing policy, GreenLake proposal validation.

The correct answer is D. The business value of the proposed HPE Synergy design is the more flexible, scalable composable-fabric architecture compared with traditional blade designs. HPE Synergy uses a primary/satellite networking architecture with Virtual Connect and Interconnect Link Modules, allowing network connectivity to scale across multiple frames while reducing upstream cabling, top-of-rack dependency, and aggregation-port consumption. HPE describes the Virtual Connect SE 100Gb F32 design as using a disaggregated, rack-scale primary/satellite architecture to consolidate data center network connections, reduce hardware, and scale network bandwidth across multiple HPE Synergy frames. That is the financial point: the customer gains higher fabric flexibility and expansion capability without replicating a full set of expensive intelligent fabric modules in every frame. Option A is not the relevant benefit and overstates the GPU expansion concept. Option B is technically true about FC capability, but it does not describe the primary business and financial value of the proposed multi-frame architecture. Option C is a narrower compute-module feature and is not the strongest financial argument. Reference/topics: HPE Synergy business value, Virtual Connect primary/satellite fabric, network consolidation, financial-impact presentation.